FLYSKY RECEIVER SETUP INSTALL
FLYSKY RECEIVER SETUP DRIVER

Plug the ST-Link USB adapter and check if the device is detected and driver is successfully installed. ST-Link UtilityВ setup usually also installs the required ST-Link USB adapter driver. Follow the installation process by simply clicking in the button. You should connect only GND, SWCLK and SWDIO lines in this case. Golden rule: do not connect the 3.3V power from the ST-LINK dongle if your receiver is connected to external power source (Flight Controller, BEC or other). Programming pinout diagram for Flysky FS-X14S receiver:Д®xample of the connected FS-iA8X receiver programming pads to the ST-Link adapter.Д®xample of the connected FlyskyВ FS-X14SВ receiver programming pads to the ST-Link adapter: Pinout diagram for Flysky FS-X6BВ receiver: Pinout diagram for Flysky FS-A8SВ receiver: Pinout diagram for Flysky FS-iA8X receiver: None of the tested receivers requires this line, so donвЂ™t bother connecting it. RSTВ signal should not be necessary unless вЂњConnect under resetвЂќ is needed. Usually they are not labeled so you need to follow the pinouts supplied below. Most of the receivers have programming pads on theВ PCB board. All protocols (IBUS, SBUS and PPM) are supported. The alternative firmware isВ kindly provided by Cleric-KВ and can be found in this github repository.В The prebuilt images have two versions each вЂ“ one which injects the Signal Strength into channel 14 and one for channel 8.

FLYSKY RECEIVER SETUP INSTALL

You will need to download and install ST-Link Utility: (on Banggood, Aliexpress or Ebay)ДЄlso youвЂ™ll probably need a few jumper wires for connecting the ST-Link adapter to the receiver programming pads. YouвЂ™ll need the ST-LINK programming adapter to flash the alternative firmware to the FlySky receiver.В Any ST-LINK V2 USB adapter should work and can be obtained for less than 3$. But no info is sent to the flight controller. In fact all of these receivers (except A8S and 8A) are reading the RSSI and sending it back to the transmitter in the telemetry link. RX2A Pro/ Pro V1 вЂ“ Reported to work with the the A8S firmware.Flit10 вЂ“ Reported to work with the IA6B firmware.The best and most universal solution is to flash the alternative receiver firmware with RSSI signal calculated and injected into one of the channels (usually CH8 or CH14). Even calculating the Link Quality (LQ) by the lost packets is not possible if your Flysky receiver outputs iBUS signal.

In fact none of the original Flysky receivers outputs RSSI information to the flight controller via one of the channel or telemetry link. Most of the Flysky receivers lacks one very important feature вЂ“ RSSI.

Flysky receiver setup